![]() ![]() However, the program contains a hardware interrupt function triggered by a hall sensor, that helps the Arduino count the number of windings. The Arduino however is not equipped or assisted by sensors that can sense the weight. These values are nothing but the amount of copper coil (in weight) that the user wants the coil winder to wind around the 3D printed part. These values are then mapped between 0-30 (using the map function in the code). The inputs given through the potentiometer knob are just numbers between 0 -1024 (the analogue values that the Arduino reads). NOTE: You will not need this calculation if you want to wind based on the number of windings, instead of the weight of the copper coil to be wound.
0 Comments
Leave a Reply. |